Loading... Please wait...
  • Image 1
  • Image 2
  • Image 3

Hover over main image to zoom

HD Nano Pad - Clay Bar Alternative

$49.00
Quantity:
SKU:
G-09PAD

  • HD Nano pad by...
    This video is about the HD Nano pad by 3D Products. This is a...
  • HD Nano Pad & ...
    This long lasting, 6" Nano pad will quickly remove paint over ...
  • How to clay a ...
    This video is about Clay & BDX Nano pad will quickly remove p...
  • Total Car Deta...
    Part of 3D's Total Car Detail videos. This clip shows how to ...
  • AAT Compound &...
    We are going to use AAT Compound & Polish after claying the ca...


The HD NANO pad is an alternative to a clay bar for removing surface contamination from the finish.

hd-nano-pad-10.jpghd-nano-pad-1.jpg

You can't beat this thing for removing oxidation on the surface finish. Unlike a clay bar, The HD Nano Pad can be cleaned by simply rinsing off the accumulated contamination with water.

hd-nano-pad-2.jpghd-nano-pad-6.jpg

If you drop the pad on the ground, no worries. Just rinse with the Nanopad and it is ready to use again. Attaches to any velcro 6" or smaller backing plate for your dual action polisher or air sander.

nano-pad.jpghd-nano-pad-8.jpg

This HD NANO pad will last longer than a clay bar.  It is so much easier to use than a clay bar or NANO PREP TOWEL.  It leaves a clean surface that is ready for deeper correction or wax protection.  Be sure to use our SPRAY DETAILER or FINAL TOUCH as a clay lubricant when using this pad on your finish.

nano-pad-leftovers.jpghd-nano-pad-9.jpg

 

 

DIRECTIONS:

Use only on clean, cool paint and out of direct sunlight. Do not work on a surface over 144 degrees F. Please use in an inconspicuous space for the first time in case of unexpected adverse effects on painted surfaces.

1.Thoroughly wash vehicle free of dust, sand, and dirt.
2. Mist sufficent 3D or HD clay lubricant evenly onto the suface.
3. Polish the surface with the HD Nano Pad using light pressure.
4. Wipe off residue and apply wax or glaze.
Note: Use 5.5" or 6" DA backing plate. Sufficient lubricant is crucial to the Nano Pad application. Plain water is not an adequate lubricant. DO NOT use with a rotary polisher. Nano Pad is not solvent resistant. Remove tar & grease before aplication.



Body Shop Directions:
1. Spray with silicone free lubricant. Apply 6" pad with Pneumatic finishing Sander at low speed and no pressure.
2. Sanding (Because the surface is free of contaminants, it becomes much easier to create even sanding marks for the next step paint correction).
3. Use HD Cut & Polish to level the clear coat.
 

Newsletter